SuperGuppyGirl Posted August 29, 2013 Report Share Posted August 29, 2013 So have been meaning to do this for awhile, finally got off my butt and did it. 2-craft mesh full size pieces Something to hold/ hang it to back of tank Bunch of preferred moss Thread and needle Start spreading moss not to thick over mesh. Place second piece over and start time consuming task of sewing together Decide on how to attach to back of tank, I went with the left over plant bendy rings. Cut some small holes through both, learned easier to do when not together. Attach and wait to grow (fingers crossed), please excuse water as I aqua scaped to work the mesh in. So here's hoping this works, so I can start a few more panels to cover the back. Link to comment Share on other sites More sharing options...
ckmullin Posted August 29, 2013 Report Share Posted August 29, 2013 Should work good. No reason why not. Link to comment Share on other sites More sharing options...
creekbottom Posted August 29, 2013 Report Share Posted August 29, 2013 Keep it trimmed! My wall failed because I let the top shadow the bottom and then the bottom died Link to comment Share on other sites More sharing options...
SuperGuppyGirl Posted August 29, 2013 Author Report Share Posted August 29, 2013 I chose the craft mesh for that reason, I'd been reading of that issue happening so when the top starts going good I'm planning on flipping it to allow the bottom to get the full light as well. Little more work but hopefully will work. Link to comment Share on other sites More sharing options...
Recommended Posts