PseVince Posted April 2, 2013 Report Share Posted April 2, 2013 Anyone else have problems with their Output Pressure after Maintenance work and filter /Substrate changes? Quote Link to comment Share on other sites More sharing options...
Jayba Posted April 2, 2013 Report Share Posted April 2, 2013 If you have a polishing pad it's more than likely clogged. Is it blowing tiny bubbles? Quote Link to comment Share on other sites More sharing options...
shanks Posted April 2, 2013 Report Share Posted April 2, 2013 agreed or your bio is ppacked to tight causing no flow Quote Link to comment Share on other sites More sharing options...
PseVince Posted April 3, 2013 Author Report Share Posted April 3, 2013 I took the Polishing Pads out after reading on a forum about them plugging the flow..Tiny Bubbles yes .Bio may be the culprit will check it out .Thanks for the Responses .I will post what the outcome was when I tear it down this weekend. Quote Link to comment Share on other sites More sharing options...
PseVince Posted April 11, 2013 Author Report Share Posted April 11, 2013 So I unloaded the trays,rinsed,reloaded them with Bio Max and Blue/White small piece of Floss on 2 of the layers.I went one step further and took the intake hose off and thoroughly rinsed it out and a lot of debris was clogged inside it.Voila, my pressure is decent again as it should be ...Thanks again for the help ... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.