trixie

Not mine but in a lot of posts

Why is location not in a members profile

go to http://www.austinglass.com.au/The%20secret.htm

call hagen there are in edmonton

Go to Canadian Tire and get a cloth buffing pad ,then look for a wax stick of diferent grades of grit.If you cant find any PM me i have all the grades .

If your furnace dose not have a outside air to the cold air return you should install one .One for your safety and fresh air in the house all new furnace have two.

Your 8 ft 2x2 on top will hold very little it will just bend.There is not much pressure at the top most is just up from the bottom about 6 in .

Try to get or make distilled water it should have o PH of 7

Not if you beleve the paper friday

That what Edmonton started using in the water [ bleach ].Will Prime remove it.

3/16= 4.8 mil my 33 gal is 36x16 ln is 5 mil if you put two braises in the top and cut off the bevel . You should end up with 30x16 in it is not needed to cut the top edge.

There is very little pressure when it is running but when the power is turned off there is about 2LB. Take the oring off and clean ,dry it lub with water only. new 5.oo$

You might want to call before going to Aquagiant in the west as they are closing that store

http://twovoyagers.com/metamorphosis/faq/faqii.html

Are they cover by any warranty

To get better consistent absorption reduce the tube as it goes into your pump .

To get a alarm go to HD for a battery laundry room one.

The sponge can hold a lot of air take the top off and push down on the sponge under water it might be full of air.Check and tighting the inlet hose as it might be sucking air

As long as there is liquid in the tank even one lb the pressure should be close to 850 LBS Look on your tank the empty weight is stamped put it on a scale it should read tank +co2 =

do you know exactly where this place is? 118ave 39st

Make a v cut in all the coners just to make a break in the silicone so only the silicone between the glass is holding. Put a little pressure on the glass at the top and try to get a razor in just a little bit and run it down.This helps to break the seal

Take a short 2x4 and slide it along the glass hitting the edge trim go all around the tank looking for a loose spot and work from there.If it will not move try hitting the end of the 2x4 with a hamer [dont hit the glass]

There web has a 1-800-719-3890

have you asked for safe guard for horses or "VitaTrace" made by Kordon