REEFLOVER Posted July 12, 2011 Report Share Posted July 12, 2011 (edited) I need help on planing my refugium out acrylic it going to be 10x5x8 it going to on top of my 10 gal reef tank I'm going to use 1/2inch for my input and for my 1inch for my output I need help to find a how low I need to make output help pls I'm only 13 Edited July 12, 2011 by REEFLOVER Quote Link to comment Share on other sites More sharing options...
jvision Posted July 12, 2011 Report Share Posted July 12, 2011 I'm using a MaxiJet 1200 to run a 1/2" fountain in my toad tank, but it may be a little much for your fuge. You probably don't want a tonne of flow thru there. I'd try an MJ 900 or similar sized powerhead/pump Quote Link to comment Share on other sites More sharing options...
REEFLOVER Posted July 12, 2011 Author Report Share Posted July 12, 2011 Thx dont need a lot water flow but I don't nO where to put my out and how low Quote Link to comment Share on other sites More sharing options...
jvision Posted July 12, 2011 Report Share Posted July 12, 2011 If you're just going to run an open pipe, I'd keep it w/in a couple inches of the surface. If you have lockline you can place it wherever you want. If you can, run a split return. Quote Link to comment Share on other sites More sharing options...
REEFLOVER Posted July 12, 2011 Author Report Share Posted July 12, 2011 thx Quote Link to comment Share on other sites More sharing options...
REEFLOVER Posted July 14, 2011 Author Report Share Posted July 14, 2011 does any know where i can get chep bulkhead in calgary and weld on 4 in carlgary too and what taickneess of acrylic to use Quote Link to comment Share on other sites More sharing options...
Doc_Polit Posted July 15, 2011 Report Share Posted July 15, 2011 You can probably get away with 1/4" acrylic. For your acrylic and Weld On, there are a couple of good options in Calgary. Try Laird Plastics and/or Industrial Plastics & Paints. As far as bulkheads, you can make your own out of PVC parts. Google DIY Bulkhead. If you have no luck, PM me and I will help you out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.